Rockwell Automation Logix5000 Systems: Connecting PowerFlex 40 Drives over an EtherNet/IP Network Quick Start - Manual (Page 21)

Rockwell Automation Publication IASIMP-QS029A-EN-P - February 2012 21
Chapter
2
Add the PowerFlex 40 Drive to an RSLogix 5000 Project
In this chapter, you add a 22B-V2P3N104 drive to an RSLogix 5000 project and configure it.
You also download the project to the controller so you can verify communication with the drive.
Before You Begin
You must complete these tasks before using this chapter:
• The tasks described in Before Using This Publication on page 5 , including:
– Prepare the Logix5000 control system hardware
– Prepare the computer
– Configure the networks - The tasks described in this chapter require an
EtherNet/IP network.
– Create an RSLogix 5000 project
The example RSLogix 5000 project used in this chapter uses a
CompactLogix 5370 L3 controller.
• Prepare the 22B-V2P3N104 drive as described in Chapter 1, Prepare the PowerFlex 40
Drive Hardware on page 13 , including:
– Mount the 22B-V2P3N104 Drive
– Wire Power
– Connect the EtherNet/IP Adapter to the Drive
– Configure the EtherNet/IP Adapter
What You Need
You need RSLogix 5000 software to complete the tasks described in this chapter.