Rockwell Automation 1897-NOV High Speed Analog Installation Instructions - Manual (Page 4)

Fast Isolated Analog Output Module 4
Publication CIG-5.1 – April 1998
Position the keying bands in the backplane connectors
to correspond to the key slots on the module.
Place the keying bands:
between 26 and 28
between 32 and 34
You can change the position of these bands if
subsequent system design and rewiring makes
insertion of a different type of module necessary.
Upper Connector
11022-I
I/O chassis
Place your module in any slot in the chassis
except the leftmost slot which is reserved for
processors or adapters.
Key the Backplane Connector
2
Locking bar
Cable Connector
Module
Connector
11023-I
Module End of
1771-NC cable
3
1. Slide the locking bar up.
2. Insert the cable connector into the mating connector on the
front of the module.
3. Slide the locking bar down over the mating pins on the
module to lock the connector onto the module.
Connect the Cable to the Module