Rockwell Automation 20D Lifting Mounting PowerFlex 700S and 700H Drives (Frame 10 - 14) - Manual (Page 8)

8 Lifting & Mounting PowerFlex® 700S and 700H Drives (Frames 10 - 14)
Step 3: Mounting the Drive
to the Floor and/or Wall Floor Only Mounting
Secure the drive to the floor with anchor bolts in the front corner holes of
the enclosure base plate. Additionally, secure the drive using the mounting
plates as needed (Rittal part no. 8800-210 or equivalent). Do this as close as
possible to the choke assembly plate. With this method, the holes through
the base plate must be drilled on site.
Important: If it is important to align the drive cabinet vertically with adja-
cent Rittal cabinets, you may need to place shims under the
drive cabinet or use leveling feet throughout the cabinet line-up.
The Allen-Bradley factory may have removed the standard
plastic plugs from the bottom of the cabinet when installing the
shipping feet. This reduces the height of the cabinet by 2 mm.
Wall Mounting
Secure the drive to the floor with anchor bolts in the front corner holes of
the enclosure base plate. Secure the drive by bolting the adjustable lifting
rails to the rear wall or supporting structure.
wall