Rockwell Automation 44887-PUB, 44887 Enwatch User Manual
Page 19

Publication GMSI10-UM031C-EN-E - January 2009
Installing the Enwatch 15
11. Select 8 - Assign Network Option, and set it to the 10 Base T Port.
12. Select 9 - Assign Debug Level, and set it to OFF unless you want to
see the debug messages from the Enwatch unit.
13. Shut down the Enwatch unit by removing the AC power, and turn it
back on. Look at the configuration settings and make sure the MAC and
IP address are correct.
Intelligent Transducer Adapter Type 1) V 1.2
Copyright Icon Research Ltd 1998/99
Configure Adapter Menu:
1 - Default Settings
2 - Assign Host MAC
3 - Assign Host IP
4 - Assign Host UDP Port
5 - Assign Subnet Mask
6 - Assign Gateway IP
7 - Assign Name
8 - Assign Network Option
9 - Assign Debug Level
ESC - Back to Main Menu
Make your selection (1-9) : 8
Assigning Network Option
Currently using Ethernet 10 Base T Port
Network Options Available:
1 : Ethernet 10 Base T
2 : Ethernet 10 Base 2
Enter New Network or ESC to abandon :
Intelligent Transducer Adapter Type 1) V 1.2
Copyright Icon Research Ltd 1998/99
Configure Adapter Menu:
1 - Default Settings
2 - Assign Host MAC
3 - Assign Host IP
4 - Assign Host UDP Port
5 - Assign Subnet Mask
6 - Assign Gateway IP
7 - Assign Name
8 - Assign Network Option
9 - Assign Debug Level
ESC - Back to Main Menu
Make your selection (1-9) : 9
Assigning Debug Level
Debug Options Available:
0 : Off
1 : Basic System Sampling & Message Processing
2 : (1) + Full Rx & Tx Message Display
3 : (2) + Interrupt Firing Notifications
Debug Level 1 Currently Set
Enter New Debug Level or ESC to abandon :