Rockwell Automation SD3100 DISTRIB PWR SYS SD3100 DC PWR MODULE - Manual (Page 42)

3-8 SD3100 Power Modules
Note that the TE signal ground is not used by the SD3100 drive’s control components,
but may be used by other drives in the lineup.
Figure 3.6 shows the typical grounding of the SD3100 drive.
3.9 For Information on Initial Start-Up of the Drive
Instruction manual S-3011, Distributed Power System SD3000 Diagnostics,
Troubleshooting, and Start-Up Guidelines, describes the procedures to follow and the
precautions that should be taken when first powering up the SD3100 drive. Please
refer to the appropriate sections of this manual when starting up your drive.
Figure 3.6 – SD3100 Grounding
Control Xfmr
X2
To control components
on other drives
To Bldg
Steel
TE
PE
Motor
SD3100 Drive Enclosure
Ground Rod or Grid
(only one grounding point
per system)
!
ATTENTION: Only qualified personnel familiar with the construction and
operation of this equipment and the hazards involved should install,
adjust, operate, or service this equipment. Read and understand this
manual and other applicable manuals in their entirety before proceeding.
Failure to observe this precaution could result in severe bodily injury or
loss of life.