Rockwell Automation 20D PowerFlex 700S and 700H Frame 12 DC Bus Connector Kit - Manual (Page 26)

Publication PFLEX-IN022A-EN-P
26 PowerFlex® 700S and 700H Frame 12 DC Bus Connector Kit
2. Secure the bus bar to the DC+ terminal using a M10x30 bolt, flat and lock
washer and hex nut.
Important: Do not fully tighten this assembly. Final torque must be applied
after all bus bars have been installed.
Step 14: Install the Right
Side DC– Terminal Bus Bar 1. Insert, from right to left, the right side DC– terminal (curved, L-shaped) bus
bar into and through the insulated grommet in the air flow plate closest to the
front of the enclosure as shown below.
Verify that the bus bar is in front of the DC– terminal on the right side of the
drive and the Z-shaped bus bar on the left side of the drive and that the
connection holes align.
Secure to DC+
terminal
Note: previously installed parts not shown for clarity only.
Verify bus bar is in
front of DC- terminal
and holes align
Verify bus bar is in front
of Z-shaped bus bar and
holes align