Rockwell Automation WebPak 3000 ControlNet Communications Board I/O with ControlLogix Processor User Manual
Introduction
©2001 Rockwell International Corporation
ControlNet is a trademark of ControlNet International, Ltd.
FlexPak, WebPak, RSLogix 5000, RSNetWorx, and ControlLogix are trademarks of
Rockwell Automation.
Using WebPak
3000
ControlNet
Communications Option Board I/O
With a ControlLogix
Processor
Instruction Manual D2-3483
Introduction
This manual describes how to configure WebPak 3000 ControlNet Communication Option board I/O for use
with a ControlLogix processor.
This manual is intended for use by personnel familiar with the installation and operation of the WebPak 3000
drive and the installation, programming, I/O configuration, and operation of the ControlLogix processor using
RSLogix 5000
software and RSNetWorx
for ControlNet software.
Related Publications
You must be familiar with the documentation that describes your system configuration. This may include, but is
not limited to, the publications listed in table 1.
Getting Assistance from Reliance Electric
If you have any questions or problems with the products described in this instruction manual, contact your local
Reliance Electric sales office. For technical assistance, call 1-800-726-8112.
!
ATTENTION: Only qualified personnel familiar with the construction and operation of this
equipment and the hazards involved should install, adjust, operate, and/or service this equipment.
Read and understand this instruction manual in its entirety before proceeding. Failure to observe
this precaution could result in severe bodily injury or loss of life.
ATTENTION: The user must provide an external, hardwired emergency stop circuit outside of
the drive circuitry. This circuit must disable the system in case of improper operation. Uncontrolled
machine operation may result if this procedure is not followed. Failure to observe this precaution
could result in bodily injury.
ATTENTION: The user is responsible for conforming with all applicable local, national, and
international codes. Failure to observe this precaution could result in damage to, or destruction
of, the equipment.
Table 1 – Related Publications
Manual No.
Title
•
D2-3425-2
ControlNet Network Communication Option Board For Use With FlexPak 3000 and
WebPak 3000 DC Drives
•
D2-3443
WebPak 3000 DC Drive Hardware Reference
•
D2-3444
WebPak 3000 DC Drive Software Reference
Trademarks not belonging to Rockwell Automation are property of
their respective companies.