Rockwell Automation SP120 AC Drive Demo Unit - Manual (Page 11)

Programming Basics 3-3
The following table provides detailed steps for keypad
operation.
7
The key issues stop and fault reset commands to the drive.
8
The key issues start commands to the drive when
P-10 = 1.
9
In display mode, the key increments the local speed reference.
In program mode, this key increments the parameter number or
parameter value.
Table 3.2 – Keypad Description
Table 3.3 – Keypad Operation
Desired Action User Steps
Start the unit
Press to start the drive.
Note that for to work, a connection must be
present between terminals 2 and 3. In addition,
parameter P-10 must be set to 1.
Stop the unit
Press to stop the drive.
Increment the local
speed reference While in display mode ( PROGRAM LED is off), press
to increase speed.
Decrement the local
speed reference While in display mode ( PROGRAM LED is off), press
to decrease speed.
View the value of
the present display
parameter While in display mode ( PROGRAM LED is off), the
value of the present display parameter is normally
displayed.
View the number of
the present display
parameter While in display mode ( PROGRAM LED is off), press
and release once. The present display
parameter number will be displayed for 2 seconds.
The display will then return to the present
parameter value.
Increment the
display parameter
number While in display mode ( PROGRAM LED is off), press
until the desired parameter is displayed.
Following a 2-second delay, the parameter value
will be displayed.