Rockwell Automation 6155F-NPXPDC Compact Non-display Computers - Manual (Page 7)

Compact Industrial Non-display Computers 7
Rockwell Automation Publication 6155R-IN002E-EN-P - July 2013
Required Tools
These tools are required for computer installation:
•
#2 Phillips screwdriver
•
Drill motor and drill bit
•
Antistatic wrist strap (recommended)
Mounting Clearances
Review the computer dimensions to make sure you allow adequate clearance around the
computer for ventilation and cable connections.
When mounted in an enclosure or high temperature area, the ambient temperature around the
computer must not exceed the operating temperature range.
Use this clearance For
25 mm (1 in.) Sides of computer
51 mm (2 in.) Top of computer
13 mm (0.5 in.)
(1)
(1) This clearance is not required when provided mounting hardware is used.
Bottom of computer
None Rear of computer
Adequate clearance for any cables used that extend beyond the handle. Front of computer