Rockwell Automation 6155R 200R VersaView Industrial Non-display Computers - Manual (Page 7)

VersaView Industrial Non-display Computers 7
Publication 6155R-IN001I-EN-P - July 2007
Required Tools
These tools are required to rack- or machine-mount your computer:
• #2 Phillips screwdriver
• Drill motor and drill bit
Mounting Clearances
Review the product dimensions to make sure you allow adequate clearance on the
sides and rear of the computer for ventilation and cable connections. You must also
be able to remove the covers to install or remove peripheral components.
When mounted in an enclosure or high temperature area, the ambient temperature
around the computer must not exceed the operating temperature range.
Install the Computer
The computers support various mounting options.
• Machine mount (200R and 700R)
• Wall mount (200R)
• DIN rail mount (200R)
• Rack mount (1400R)
• VESA mount (200R)
Mount the Computer on a Machine
You can mount the VersaView 200R and 700R computers on a shelf inside a
machine by using mounting brackets. The brackets secure the computer to the
shelf.
1. Attach the two mounting brackets to the bottom of the computer by using
four of the provided screws.
For the 200R computer, use four of the M3 x 5 mm panhead screws, and
torque to 0.678 Nm (6 lb-in).