Rockwell Automation 2100 CENTERLINE Bolted Pressure Contact Switch - Manual

1 Publication 2100-IN049B-EN-P - February 2008
Instructions
CENTERLINE
®
2100 Motor Control Centers
600A, 800A, and 1200A Bolted Pressure
Contact Switch
CENTERLINE
®
2100 Motor Control Centers
Introduction The intent of this publication is to provide field instructions for
connection, operation, and service of the 600A, 800A, or 1200A Bolted
Pressure Contact Switch (BPS) used in the CENTERLINE
®
2100 motor
control center (MCC) sections.
The BPS is supplied from the factory in a frame mounted design
construction as an MCC main fused disconnect, an MCC main
non-fused isolation switch, a motor control unit disconnect, or a
feeder disconnect. Being a factory frame mounted design, the BPS
unit is not intended to be field installed within an MCC section, nor is
there a “plug-in” design available. Also, the BPS is either a “top cable”
design (cables entering or exiting from the top of the BPS) or “bottom
cable” design (cables entering or exiting from the bottom of the BPS).
The following publications may be useful:
•
CENTERLINE 2100 Low Voltage Motor Control Centers Instruction
Manual, publication 2100-IN012, which is supplied with the
MCC.
•
The unit wiring diagram supplied with the MCC unit.
ATTENTION
To prevent injury or death to personnel installing
or servicing the switch, disconnect the motor
control center remote power source(s) so that no
power is present.