Additional resources – Rockwell Automation 2080-LC30-10QWB_10QVB Micro830 10 Point Programmable Controllers User Manual
Page 6
6 Micro830 10 Point Programmable Controllers
Publication 2080-IN002B-EN-P - April 2014
Additional Resources
If you would like a manual, you can:
• download a free electronic version from the Internet:
• purchase a printed manual by contacting your local Allen-Bradley distributor or
Rockwell Automation representative
ATTENTION:
• Be careful when stripping wires. Wire fragments that fall into the controller
could cause damage. Once wiring is complete, make sure the controller is
free of all metal fragments.
• Do not remove the protective debris strips until after the controller and all
other equipment in the panel near the module are mounted and wired.
Remove strips before operating the controller. Failure to remove strips
before operating can cause overheating.
• Electrostatic discharge can damage semiconductor devices inside the
module. Do not touch the connector pins or other sensitive areas.
• The USB and serial cables are not to exceed 3.0 m (9.84 ft).
• Do not wire more than 2 conductors on any single terminal.
Resource
Description
Micro830
®
and Micro850
®
Programmable
Controllers User Manual,
publication
A more detailed description of how to install and use your
Micro830 and Micro850 programmable controllers.
Micro800
®
AC Power Supply Installation
Instructions, publication
Information on installing and wiring the optional AC power supply.
Micro800 Plug-in Modules User Manual,
publication
Installation, wiring descriptions, and specifications, for the
different Micro800 plug-in modules.
Industrial Automation Wiring and
Grounding Guidelines, publication
More information on proper wiring and grounding techniques.