Rockwell Automation 6151 Industrial Computer - Manual (Page 22)

2–12 Installation Instructions
Publication 6151-UM001C-EN-P
1. Connect the cables according to the options in your Industrial
Computer (see below).
2. Route and secure the cables. In cases where the cable crosses a door
hinge, be sure to leave enough excess cable for a loose fit in all door
positions.
3. Coil and secure any extra cable length in a convenient location.
Video Cables
The Video cable is equipped with a conventional HD15 connector at
each end.
Figure 8
Standard VGA Video - HD-15
1 2 3 4 5
6 7 8 9 10
11 12 13 14 15
HD15
View looking into the Pin
End of the Male connector
Table E
Standard Cable Construction
Monitor HD15 Signal Description Computer HD15
2 Green Video 2
7 Green Video Ground 7
1 Red Video 1
6 Red Video Ground 6
3 Blue Video 3
8 Blue Video Ground 8
5 Composite Sync 5 (Not Used)
11 (Floating) ID0 11
12 (Floating) ID1 12
4 (Gnd) ID2 4
9 Not Connected 9
14 Vertical Sync 14
10 Sync Ground 10
15 Control 15 (Not Used)
13 Horizontal Sync 13
Communication Setups