Rockwell Automation 6153 Industrial Computers (6153, 6154) - Manual (Page 23)

Bulletin 6153 and 6154 Industrial Computers with Integrated CRT 23
Publication 6153-2.0
To open the computer chassis
You may have to open the computer chassis to install a card or for
some other reason.
1. Disconnect and remove cables from the computer chassis.
2. Remove the two or three Phillips-head screws at the rear of the
unit.
3. Slide the chassis straight back and out, taking care to support the
chassis as it slides free.
4. Some versions have a ground wire that must be detached from a
Phillips-head screw before the chassis can be completely
removed.
Preparation for Shipment
If it is necessary to ship the computer from one site to another, it
should be removed from the panel or cabinet in which it has been
installed. Whenever possible, the computer should be repacked in its
original shipping carton.
!
ATTENTION: Never try to ship the Industrial
Computer while it is mounted in a panel. Doing so
could result in damage to the panel or the Industrial
Computer.
To remove the computer from the panel, reverse the installation
procedures given previously in this manual.
Note: Be careful to remove the Ground wire before removing the
computer from the panel or rack.
Maintenance