Rockwell Automation 2711P-RLxxx Backlight Replacement for PVPlus and PVPlus CE Terminals - Manual (Page 10)

10 Backlight Replacement
Publication 2711P-IN019D-EN-P - February 2007
Replace Display Module Bezel
Follow these steps to replace the bezel.
1. Make sure bezel is free of lint and marks before reattaching.
2. Attach the following connectors.
The number of connectors varies by model.
• IrDa connector (if present)
• Function key connector
• Touch screen connector
3. Place the back of the display module over the bezel.
Be careful not to pinch any of the cables. Allow the touch screen connector
to extend out of the access opening.
4. Attach touch screen connector.
5. Replace the sealing gasket (shown in step 6 on page 4).
6. Attach screws that secure display module to bezel and tighten to a torque of
1.35…1.58 Nm (12…14 lb-in).
7. Attach the small metal plate to the back of the touch screen display module
by using two screws (shown in step 3 on page 3).
8. Torque to 0.68 Nm (6 lb-in).