Rockwell Automation 6189V-MCLPS2 Mounting Clips - Manual (Page 4)

4 Mounting Clips
Publication 6176M-IN002A-EN-P - August 2006
Before You Begin
Before unpacking the product, inspect the shipping carton for damage. If damage is
visible, immediately contact the shipper and request assistance. Otherwise, proceed
with unpacking.
Keep the original packing material in case you need to return the product for repair
or transport it to another location. Use both the inner and outer packing cartons to
provide adequate protection for a unit returned for service.
Installation Guidelines
Follow these guidelines to make sure your product provides safe and reliable
service.
• The installation site must have sufficient power.
• The enclosure must have sufficient space around air inlets and outlets to
provide the circulation necessary for cooling. Never allow air passages to
become obstructed.
• The ambient air temperature must not exceed the maximum operating
temperature. Consider heat produced by other devices in the enclosure. You
may need a user-supplied fan, heat exchanger, or air conditioner to meet
this condition.
ATTENTION
This product is intended to operate in an industrial or control
room environment, which utilizes some form of power
isolation from the public low-voltage mains. Some computer
configurations may not comply with the EN 61000-3-2
Harmonic Emissions standard as specified by the EMC
Directive of the European Union. Obtain permission from the
local power authority before connecting any computer
configuration that draws more than 75 W of ac power directly
from the public mains.
TIP
Hot air rises. The temperature at the top of the enclosure is often
higher than the temperature in other parts of the enclosure,
especially if air is not circulating.
IMPORTANT
The product can operate at a range of extremes. However, the life
span of any electronic device is shortened if you continuously
operate the product at its highest, rated temperature.