Rockwell Automation 1756-Lx_Mx ControlLogix Controller and Memory Board Installation Instructions - Manual (Page 23)

ControlLogix Controller and Memory Board 23
Publication 1756-IN101L-EN-P - June 2008
Install a CompactFlash Card in a Series B Controller
1. Turn the keyswitch to the PROG position.
2. Open the door of the controller.
3. Push the CompactFlash latch to the left.
4. Insert the CompactFlash card with the A-B lSogo pointing left.
5. Release the latch and make sure it slides over the CompactFlash card.
WARNING
When you insert or remove the CompactFlash card an electrical arc can occur.
This could cause an explosion in hazardous location installations. Be sure
that power is removed or the area is nonhazardous before proceeding.
ATTENTION
If you are not sure of the contents of the CompactFlash card, before you
install the card turn the keyswitch of the controller to the PROG position.
Depending on the contents of the card, a power cycle or fault could cause the
card to load a different project into the controller.
RS232
BATTERY PORT
1-DCD
2-RXD
4-DTR
3-TXD
5-GND
DSR-6
CTS-8 RTS-7
N/C-9
1
2
BATTERY DATE
UP
COMPACT FLASH
2
To
Insert 1
To Eject
1 + 2 2
1
1