Rockwell Automation 1756-CNB ControlLogix ControlNet Bridge Module, Series E Installation Instructions User Manual
Controllogix controlnet interface module, Installation instructions, Contents about this publication
Publication
1756-IN604A-EN-P - February 2006
Installation Instructions
ControlLogix ControlNet Interface Module
Catalog Numbers 1756-CNB, 1756-CNBR, Series E
Contents
About This Publication
Use this document as a guide to install the ControlLogix ControlNet Bridge
module.
For
See Page
European Hazardous Location Approval
North American Hazardous Location Approval
Prevent Electrostatic Discharge
About the 1756-CNB and 1756-CNBR Series E Modules
Understand Standalone and Redundant Control
Install or Remove the Module Under Power
Connect the Module to the Network
Interpret the Module Status Indicator and Display
This manual is related to the following products:
Table of contents
Document Outline
- 1756-IN604A-EN-P
- About This Publication
- Important User Information
- European Hazardous Location Approval
- North American Hazardous Location Approval
- Environment and Enclosure
- Prevent Electrostatic Discharge
- About the 1756-CNB and 1756-CNBR Series E Modules
- Understand Standalone and Redundant Control
- Before You Begin
- Install or Remove the Module Under Power
- Install the Module
- Connect the Module to the Network
- Connect to the Network with a Tap
- Connect a Programming Terminal to the Network with a 1786-CP Cable
- Troubleshoot the Module
- Interpret the Module Status Indicator and Display
- ControlNet Network Channel Status Indicators
- Specifications
- Additional Resources
- Rockwell Automation Support
- Installation Assistance
- Backcover