About the ethernet/ip daughtercard, Required software, Related publications – Rockwell Automation 1788-ENBT EtherNet/IP Daughtercard Installation Instructions User Manual
Page 4: Identifying daughtercard components
4 EtherNet/IP Daughtercard
Publication 1788-IN054A-EN-P - September 2002
About the EtherNet/IP Daughtercard
The network daughtercard architecture defines a common
hardware and software interface that several different
network interface cards will support. This lets products that
have been designed to support the network daughtercard
option support several different Rockwell Automation
networks.
You can install the 1788-ENBT EtherNet/IP daughtercard in any host device that
supports the daughtercard.
(1)
Required Software
Use RSLogix 5000 programming software V11 or later to configure a
FlexLogix/DriveLogix system for use with the EtherNet/IP daughtercard.
Related Publications
Identifying Daughtercard Components
(1)
The host device must provide suitable power source per the restrictions in the specifications table on
Publication Title
Publication Number
EtherNet/IP System Overview
ENET-SO001
EtherNet/IP Media Planning and Installation Manual
ENET-IN001
EtherNet/IP Performance and Application Guide
ENET-AP001
FlexLogix System User Manual
1794-UM001
EtherNet/IP Daughtercard User Manual
1788-UM054
31447-M
M
S
N
S
LNK U%
E
N
E
T
module status LED
network status LED
link status LED
utilization percent LED
RJ45 cable connector