Rockwell Automation 1762-OB32T MicroLogix Solid State 24V DC Source Output - Manual (Page 10)

10 MicroLogix 1762-OB32T Solid State 24V DC Source Output Module
Publication 1762-IN020B-EN-P - June 2013
Panel Mounting
Use the dimensional template shown below to mount the module. The preferred mounting
method is to use two M4 (#8) panhead screws per module. M3.5 (#6) panhead screws may also
be used, but a washer may be needed to ensure a good mechanical contact. Mounting screws are
required on every module.
System Assembly
The expansion I/O module is attached to the controller or another I/O module by means of a
flat ribbon cable
after mounting as shown below.
TIP
Use the pull loop on the connector to disconnect modules. Do not pull on the
ribbon cable.
90
(3.54) 100.06
(3.939)
40.4
(1.59)
40.4
(1.59)
14.2
(0.568)
MicroLogix
1100/1200/1400 1762 I/O 1762 I/O 1762 I/O
95 (3.74)
44914
For more than 2 I/O modules: measure (number of modules - 1) x 40 mm (1.59 in.)
NOTE: All dimensions are in mm (in.). Hole spacing tolerance: ±0.4 mm (0.016 in.).
44569
Bus connector covers
1762 expansion
bus connector
cover