What you need, Choose your fiber optic cables, What you need choose your fiber optic cables – Rockwell Automation 1768-M04SE CompactLogix SERCOS interface Module Installation Instructions User Manual
Page 9

9
Publication
1768-IN005A-EN-P - December 2005
What You Need
Choose Your Fiber Optic Cables
IMPORTANT
This product is grounded through the DIN rail to chassis
ground. Use zinc plated yellow-chromate steel DIN rail
to assure proper grounding. The use of other DIN rail
materials (e.g. aluminum, plastic, etc.) that can corrode,
oxidize, or are poor conductors, can result in improper
or intermittent grounding. Secure DIN rail to mounting
surface approximately every 200 mm (7.87 in.) and use
end-anchors appropriately.
Item
Catalog Number or Size
1768 CompactLogix power supply
1768-PA3
1768 CompactLogix controller
1768-L43
1769 end cap
(1)
(1)
You need a 1769-ECR end cap even if you aren’t using any 1769 I/O modules. Put it on the
right side of the controller.
1769-ECR
fiber optic cables
See Choose Your Fiber Optic Cables.
DIN rail or mounting screws (one
or the other but not both)
DIN rail
Either of these sizes:
• 35 x 7.5 mm (EN 50022 - 35 x 7.5)
• 35 x 15 mm (EN 50022 - 35 x 15)
screws
M4 or #8 panhead screws
For This Distance
Then
See Page
Up to 32 m (105 ft)
Choose a Plastic Fiber Optic Cable
More than 32 m (105 ft)