Rockwell Automation 1771-IMD AC/DC(220V) INPUT Installation Instructions - Manual

Installation Instructions
Publication 1771Ć5.27
AC/DC (220V) Input Module
Cat. No. 1771ĆIMD Series B
This document provides information on:
•
important pre-installation considerations
•
power supply requirements
•
initial handling
•
installing the module
•
using the indicators for troubleshooting
•
module specifications
This module must be used with a 1771 B Series I/O chassis. If you
are using a 1771-ASB remote I/O adapter you may use any
combination of I/O modules. Otherwise, make sure no other input
module or single card block transfer module is placed in the same
I/O group.
This module contains input filtering to limit the effects of voltage
transients caused by contact bounce and/or radiated electrical noise.
The delay due to filtering is listed in the Specifications section.
European Union Directive Compliance
If this product has the CE mark it is approved for installation within
the European Union and EEA regions. It has been designed and
tested to meet the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards,
in whole or in part, documented in a technical construction file:
•
EN 50081-2EMC – Generic Emission Standard, Part 2 –
Industrial Environment
•
EN 50082-2EMC – Generic Immunity Standard, Part 2 –
Industrial Environment
This product is intended for use in an industrial environment.
To The Installer
PreĆinstallation
Considerations