Rockwell Automation 1771-OD AC (120V) Isolated Output Module Installation Instructions - Manual

Publication 1771-IN078A-EN-P - October 2002
AC (120V) Isolated Output
Module
(Catalog Number 1771-OD)
This document provides information on:
To See page
Important User Information 1
Pre-installation Considerations 4
Suppression 4
Calculate Power Requirements 5
Determine Module Placement 5
Prevent Electrostatic Discharge 5
Key the Backplane Connector 6
Install the Module and Field Wiring Arm 7
Connect Wiring to the Module 8
For this reference information See page
Interpreting the Status Indicators 10
Replacing a Fuse 10
Specifications 11
Because of the variety of uses for the products described in this
publication, those responsible for the application and use of these
products must satisfy themselves that all necessary steps have been
taken to assure that each application and use meets all performance
and safety requirements, including any applicable laws, regulations,
codes and standards. In no event will Rockwell Automation be
responsible or liable for indirect or consequential damage resulting
from the use or application of these products.
Any illustrations, charts, sample programs, and layout examples
shown in this publication are intended solely for purposes of
example. Since there are many variables and requirements associated
with any particular installation, Rockwell Automation does not
assume responsibility or liability (to include intellectual property
liability) for actual use based upon the examples shown in this
publication.
Installation Instructions
To The Installer
Important User
Information