Rockwell Automation 1771ACN/B_1771ACNR/B,D17716.5.123 U.MNL CONTROLNET ADAPTER - Manual (Page 22)

Installing Your ControlNet Adapter Module 2–8
Publication 1771-6.5.123 – May 1996
!
ATTENTION: Do not allow any metal portions of
the tap to contact any conductive material. If you
disconnect the tap from the adapter, place the dust cap
back on the straight or right angle connector to prevent
the connector from accidentally contacting a metallic
grounded surface.
tap
dust cap
segment 1
20093-I
2. Remove and discard the dust caps from the adapter BNC jacks.
3. Connect this tap’s straight or right angle connector to the A
BNC connector on the adapter.
20093-I
Important: To prevent inadvertent reversal of
the tap connections (resulting in incorrect LED
displays and troubleshooting), check the tap
drop cable for a label indicating the attached
segment before making your connection.
segment 1
tap
4. For redundant adapters (1771-ACNR), remove (and save) the
dust cap located on the straight or right angle connector of the
designated tap on the second segment (segment 2).
tap
dust cap
segment 2
20093-I