Rockwell Automation 1746-XXXX SLC 500 32-Channel Digital I/O Modules Installation Instructions - Manual (Page 10)

10 SLC 500™ 32-Channel Digital I/O Modules
Publication 1746-IN028A-EN-P - October 2003
Installation of the Octal Label Kit (for PLC
®
Processors Only)
The octal label kit consists of an octal filter label and a door label. In a PLC system,
use these octal labels to replace the decimal labels that are attached to the I/O
modules.
Applying the Octal Filter Label
1. Remove the octal filter label from its paper carrier.
2. Align the octal filter label numbers horizontally to the module color bar and
over the decimal filter numbers, as shown in the illustration on page 8.
3. Apply the octal label to the filter.
4. Press firmly to ensure proper adhesion of the label.
Applying the Octal Door Label
1. Remove the octal door label from its paper carrier.
2. Align the octal label directly over the decimal door label on the inside of the
door.
3. Apply the octal label to the door.
4. Press firmly to ensure proper adhesion of the label.
TIP
The octal label kit can be obtained from your Allen-Bradley
Distributor. The octal kit is ordered based on the catalog number
of the I/O module. Please refer to the SLC 500 Modular Hardware
Style User Manual, publication 1747-UM011, or the Control and
Information Products Price List, publication ACIG-PL001, for a
complete listing of octal label kit catalog numbers.
1746-XXXX 1746-XXXX (OCTAL)
OCTAL
Module Color Bar
Beveled Edge
Octal Filter Label
Octal Door Label