Rockwell Automation 1790D-XXXX DeviceNet 32 Point Digital Base Terminal Block CompactBlock LDX I/O Series B - Manual (Page 7)

DeviceNet 32 Point Digital Base Terminal Block CompactBlock LDX I/O 7
Publication 1790-IN014A-EN-P - March 2008
Mount the Base Block
Mount the base block to a panel or DIN rail. We recommend that you
ground the panel or DIN rail before mounting the block.
Dimensions
Mount on a Panel
For panel mounting, use these steps.
1. Place the block against the panel where you want it mounted.
2. Gently pull and position the expansion cover to the left.
3. Place a center punch, nail, or similar device through the
mounting holes in the block and make two marks on the
panel at the lower-left and upper-right corners of the module.
4. Remove the block and drill two holes in the panel to
accommodate each of the mounting screws.
5. Replace the block on the panel and place a screw through
each of the two mounting holes.
6. Tighten the screws until the block is firmly in place.
1790D-T32BVO
32 INPUTS - 24V DC
0 1 2 3 4 5 6 7
8 9 10 11 12 13 14 15
16 17 18 19 20 21 22 23
24 25 26 27 28 29 30 31
DC INPUTS
Expansion
Cable
Cover
32-point Base Module
166 mm
(6.53 in.)
42.5 mm
(1.67 in.)
44250