Rockwell Automation 1757-SRC1_3_10_50_100 ProcessLogix Redundancy Module Cable Installation Instructions - Manual (Page 2)

2 Redundancy Module Cable
Publication 1757-IN014B-EN-P - November 2002
Throughout this publication, notes may be used to make you aware of safety considerations.
The following annotations and their accompanying statements help you to identify a potential
hazard, avoid a potential hazard, and recognize the consequences of a potential hazard:
Installing the Cables
Follow this procedure to install the redundancy module cables:
1. Open the front door on the first redundancy module in your redundant chassis pair
(RCP) and remove the black protective plug.
2. Remove both black protective caps from the connector at one end of the cable.
3. Remove both black protective caps from the connector at the other end of the cable.
4. Plug the cable connector into the redundancy module connector.
WARNING
!
Identifies information about practices or circumstances that can cause
an explosion in a hazardous environment, which may lead to personal
injury or death, property damage, or economic loss.
ATTENTION
!
Identifies information about practices or circumstances that can lead
to personal injury or death, property damage, or economic loss.
IMPORTANT
Identifies information that is critical for successful application and
understanding of the product.
ATTENTION
!
The redundancy module cable contains optical fibers.
Avoid making sharp bends in the cable. Install the cable in
a location where it will not be cut, run over, abraded or
otherwise damaged.