Rockwell Automation 1757-SRC1_3_10_50_100 ProcessLogix Redundancy Module Cable Installation Instructions - Manual

Publication 1757-IN014B-EN-P - November 2002
Installation Instructions
Redundancy Module Cable
Catalog Numbers 1757-SRC1, -SRC3, -SRC10, -SRC50, -SRC100
Use this document to install these redundancy module cables for communication between
1757-SRM modules.
Important User Information
Because of the variety of uses for the products described in this publication, those responsible
for the application and use of these products must satisfy themselves that all necessary steps
have been taken to assure that each application and use meets all performance and safety
requirements, including any applicable laws, regulations, codes and standards. In no event will
Rockwell Automation be responsible or liable for indirect or consequential damage resulting
from the use or application of these products.
Any illustrations, charts, sample programs, and layout examples shown in this publication are
intended solely for purposes of example. Since there are many variables and requirements
associated with any particular installation, Rockwell Automation does not assume
responsibility or liability (to include intellectual property liability) for actual use based upon
the examples shown in this publication.
Allen-Bradley publication SGI-1.1, Safety Guidelines for the Application, Installation and Maintenance
of Solid-State Control (available from your local Rockwell Automation office), describes some
important differences between solid-state equipment and electromechanical devices that
should be taken into consideration when applying products such as those described in this
publication.
Reproduction of the contents of this copyrighted publication, in whole or part, without
written permission of Rockwell Automation, is prohibited.
catalog number length
1757-SRC1 1 meter
1757-SRC3 3 meters
1757-SRC10 10 meters
1757-SRC50 50 meters
1757-SRC100 100 meters