Rockwell Automation 1792-OB4E INSTL.INST ARMORBLOCK 4 OUTPUT User Manual
Armorblock 4 output module, Installation instructions
ArmorBlock is a trademark of Allen-Bradley Co. Inc.
Publication 1792-5.4 – October 1996
ArmorBlock 4 Output Module
Cat. No. 1792-OB4E Series B
To:
See page:
Install the ArmorBlock
Module
3
Connect the Wiring to the ArmorBlock Module
8
Communicate with Your ArmorBlock Module
10
Configure Your ArmorBlock Module Offline Using the DeviceNet
Manager Configuration Tool
11
Configure Your ArmorBlock Module Online Using the DeviceNet
Manager Configuration Tool
18
Reset Faults
26
Configure Your ArmorBlock Module with EDS Files
29
For this reference information
See page:
Default Configuration
14
Status indicators
34
Troubleshooting
34
Specifications
35
This 1792 ArmorBlock
I/O block module
(
Cat. No. 1792-OB4E
)
contains I/O circuits, a built-in power supply, and a built-in DeviceNet
I/O adapter. Because of its sealed housing, this 1792 I/O block requires
no enclosure. It is compatible with PLC or SLC programmable
controllers using DeviceNet scanners. The I/O values are accessible
from the PLC or SLC programmable controller data table.
This ArmorBlock module has no switches to set. You set module
parameters using the DeviceNet Manager Software (cat. no.
1787-MGR) or similar configuration tool.
Installation Instructions
Document Outline
- 1792-5.4, ArmorBlock 4 Output Module, Installation Instructions
- European Union Directive Compliance
- Install Your ArmorBlock Module
- Connect the Wiring to the ArmorBlock Module
- Communicate with Your ArmorBlock Module
- Configure Your ArmorBlock Module Offline Using the DeviceNet Manager Configuration Tool
- Configure Your ArmorBlock Module Online Using the DeviceNet Manager Configuration Tool
- Monitoring Parameters Online
- Reset Faults
- Configure Your ArmorBlock Module Using EDS Files
- Specifications
- Back Cover