Rockwell Automation 1792D-CBXXX ArmorBlock MaXum I/O Cable Bases Series B - Manual (Page 11)

ArmorBlock MaXum I/O Cable Bases Series B 11
Publication 1792D-IN009B-EN-P - September 2000
Attach the Module to the Base
1. Position the module over the mounted cable base. Align the
three captive screws in the module with the accepting
receptacles in the base.
IMPORTANT
There are 3 seating lines on the sides of the seal
block, under the captive screws. As the screws are
tightened these lines meet the cable base. At this
point the seal block is fully seated.
ATTENTION
!
Make sure all screws and end caps are securely
tightened to properly seal the base against leaks
and maintain IP67 requirements.
IMPORTANT
Make sure you properly align the screws to
complete the connections between the module
contacts and the cable contacts.
41533
Match arrows so
the seal block is
in the correct
position over the
cable base.
When the lines
of the seal block
meet the base it
is fully seated.
Seal
Block
Base