Rockwell Automation 1426-COMM-CNT PowerMonitor 5000 Unit Optional Communication Modules - Manual (Page 3)

Rockwell Automation Publication 1426-IN002A-EN-P - April 2013 3
PowerMonitor 5000 Unit Optional Communication Modules
Install a Communication
Module
Follow these steps to install a new communication module.
1. Disconnect control and voltage sensing power from the power monitor.
2. Remove the optional communication port cover by prying gently with a
small, flat-bladed screwdriver.
3. Verify that the fastening screws in the communication module are backed
out approximately 4 mm (0.16 in.) and that the fastening cams do not
protrude from the bottom of the module.
4. Carefully slide the communication module flat against the circuit board in
the slot, aligning the tabs along the module’s edges with the guides in the
socket.
IMPORTANT When installing the module into the socket, make sure that the
communication module is properly aligned into the socket prior to applying
any force. Rough handling and/or excessive force in combination with
misalignment can cause mechanical damage to the communication module or
the power monitor.
Virtual Wiring
Correction
---- S1
S2
---- S3
S4
---- S com
S com
---- K
Y
---- Z
R1 O
---- R1 com
R1 C
---- R2 O
R2 com
---- R2 C
R3 O
---- R3 com
R3 C
Module
status
Network
status
Config Loc
EtherNet/
IP
Power
USB
Device
USB
Host
LNK
ACT
I 1
I 2
I 3
I 4
L1
L2
GND
24V
com
Scom S n
Internal
24 VDC
K Y Z
Rx O Rx com Rx C
V1
V2
V3
VN
VG C
O
M
M
U
N
IC
A
T
IO
N
P
O
R
T
PowerMonitor 5000
Communication
Port Cover