Rockwell Automation 1426-COMM-CNT PowerMonitor 5000 Unit Optional Communication Modules - Manual

Installation Instructions
PowerMonitor 5000 Unit Optional Communication Modules
Catalog Numbers 1426-COMM-DNT, 1426-COMM-CNT
About This Publication This document provides instructions on how to install or replace an optional
communication module on a PowerMonitor™ 5000 unit. These are the available
optional communication modules:
• 1426-COMM-DNT - DeviceNet Optional Communication Module
• 1426-COMM-CNT - ControlNet Optional Communication Module
The communication module installs in the optional communication slot on the
front panel of the PowerMonitor 5000 unit. The installation is the same for all
communication modules regardless of communication type.
Required Tools You need the following tools:
• Torx 8 screwdriver
• Small flat-bladed screwdriver
Before You Begin
Topic Page
About This Publication 1
Required Tools 1
Important User Information 2
Install a Communication Module 3
Replace a Communication Module 5
Additional Resources 5
WARNING: Do not connect or disconnect any communication cable with power
applied to this device or any device on the network. An electrical arc can occur
and could cause an explosion in hazardous location installations. Be sure that
power is removed or the area is nonhazardous before proceeding.
ATTENTION: Work in a static free environment and wear a properly grounded
electrostatic discharge (ESD) wristband. Do not touch the communication
module connector or its internal circuitry to avoid ESD.