Rockwell Automation 1395 Digital Reference Adapter for RTP Applications - Manual (Page 27)

Publication 1395-RTP-5.2 - September 1997
Installation 4-3
Figure 4.1
Digital Reference Adapter Board Location – Port A
Connections To Drive The Digital Reference Adapter Board is connected to Microbus Port
A on the Drive through a ribbon cable connector J1 located at the top
of the board. Connection to TB3 is made through two connectors, J2
and J3. Looking into the Drive, Port A is located on the left side, and
Port B is located on the right.
External wiring is connected to the terminal block at the bottom of the
Drive enclosure. Terminals A23 through A62 (for Port A) are
reserved for wiring the Digital Reference Adapter Board to external
I/O devices (Figure 4-2).