Rockwell Automation 1326AB Cable Connector Seals - Manual (Page 3)

Connector Seals for Series B IP67 Cables for IP67 Torque Plus Motors 3
Publication 1326A-5.23 - March 1998
Mounting the Components of the Cable Seal Kit
To mount the components on the input and output connectors:
1. Refasten the input and output connectors to the motor housing by using the eight
screws provided. The table below shows the required torque for the mounting
screws of each cable:
2. Lubricate the inner surface of the two seals with o-ring lubricant.
3. Slide the larger of the two seals down onto the power input connector and the
smaller seal onto the resolver or encoder output connector until:
• the seals are seated snugly to the base of the connectors.
Cable Screw Size Torque
1326-CCU-xxx M3 13-15 in-lb
1326-CPB1-xxx M3 13-15 in-lb
1326-CPC1-xxx M3.5 20-22 in-lb