Rockwell Automation 1397 Regulated Field Supply Card - Manual (Page 9)

1397 – 5.17 September, 1997
1397 Regulated Field Supply Card 9
Installation
(continued)
❏ 7 Remove the (4) retaining
screws from the back of the
Regulated Field Supply
Card. Use these same (4)
screws to install the
Regulated Field Supply card
in the Fixed or Enhanced
Field Supply Card’s old
location. Plug either the
shorter or longer wire
harness included with the
kit into the Regulated Field
Supply Card and reattach
the (5) blue fast-on
connectors as shown.
Regulated
Field
Supply
Card
583
R/C
582
37 F1+
35 F2–
581
J8
J5
J6
58719-31
J2
J1
J3
J7
J4
J3
Short
Wire
Harness
J6
FLDP3
FLDP3
FLDP3
FLDP6 FLDP6 FLDP6
F1/37
581
583
582
F2/35
583
R/C
582
37 F1+
35 F2–
581
J8
J5
J6
58719-31
J2
J1
J3
J7
J4
1.5-30HP/230V and 3-60HP/460V Drives
— Inside Right Side Panel —
583
582
37
F1+
581
J8
J6
58719-31
J2
J3
J4
J3
J6
FLDP3
FLDP3
FLDP3
FLDP6
FLDP6
FLDP6
F1/37
581 583
582
F2/35
583
R/C
582 37
F1+
35
F2–
581
J8
J5
J6
58719-31
J2
J1
J3
J7
J4
Regulated Field Supply Card
40-60HP/230V and 75-125HP/460V Drives
— Inside Right Side Panel —
Long
Wire Harness
• For 1.5-30HP/230V and
3-60HP/460V Drives, unplug
the red P4 connector from the
Power Interface Board to free
the card.
• For 40-60HP/230V and
75-125HP/460V Drives,
unplug the red P4 connector
from Power Interface Board
connector S4 to free the card.
❏ 6 Unplug the (5) blue fast-on connectors from the Fixed or
Enhanced Field Supply Card.