Rockwell Automation 700-RTC_RTCR Type RTC RTCR Solid-State Relays - Manual (Page 3)

Publication 700-IN003C-EN-P - October 2009
Bulletin 700 Type RTC & RTCR Solid-State Relays 3
4. Insert the desired cartridge. The cartridges are keyed and must be
inserted with correct orientation (See Figure 1.).
5. Slide front housing back down carefully to avoid cable damage. Tighten
screws.
Setting the Mode and
Timing Range Figure 2. Removing Corner Cover
1. Remove the corner cover by pressing down on the top of the cover with
your thumb and slide forward (See Figure 2.).
2. Set the desired position on the sixteen position rotary switch using a
small screwdriver.
3. Replace corner cover by sliding it back into its original position.
Operation Table 1 outlines timer operation in both the on-delay and off-delay modes.
The red LED indicator on the front housing of the timer gives visual
indication of timing, timed out, and reset or stable timer conditions. At certain
settings, there may be a slight delay in the LED operation. The timing
sequence is not affected by this delay.
ATTENTION
Be careful not to damage circuit table.
ATTENTION
Unpredictable contact operation can occur if the mode
setting is changed with power applied to any terminal.
Method of removing corner cover