Rockwell Automation 150-F84L_F86L Soft Starter Protective Modules - Manual (Page 5)

PN-164127
DIR 41053-227 (Version 07)
Publication 150-IN036G-EN-E
Printed in U.S.A.
Bulletin 150 SMC-Flex (625-1250A) Series B Protective Module Installation
(Cat 150-F84L (480V), 150-F86L (600V))
Protective Modules Installation
20 lb-in
(2.3 Nm)
20 lb-in
(2.3 Nm)
10 lb-in
(1.1 Nm)
10 lb-in
(1.1 Nm)
L3 / 5
L2 / 3
L1 / 1
T3 / 6
T2 / 4
T1 / 2
1
3
2
4
WARNING: To prevent electrical shock, disconnect from power source before installing
or servicing. Install in a suitable enclosure. Keep free from contaminants.
WARNING: Protective modules must not be mounted on the load side when used with controllers that use an
inside-the-delta motor connection or with pump, linear deceleration or braking control. Installing them with a Delta motor
connection will result in immediate damage to the protective module.