Brady X-Plus II User Manual
Page 85
75
Configuration
Control Panel Parameters
1/11/07
X-Plus II User Guide
14068L-001 Rev. A
Initialize Flash Memory
This option erases all previously stored information from Flash memory.
Caution • This option completely erases the Flash memory.
To initialize Flash memory:
1.
Press the right oval to select
YES
.
2.
Enter the password. For instructions, see
.
The display shows
INITIALIZE FLASH?
3.
Press the right oval to select
YES
.
The display shows
ARE YOU SURE?
.
4.
Do you wish to continue?
• Press the left oval to select
NO
to cancel the request and return to the
INITIALIZE FLASH
prompt.
• Press the right oval to select
YES
and begin initialization.
When initialization is complete, the printer automatically exits Setup
mode, and the control panel displays
PRINTER READY
. If you exit
Setup mode while initialization is still in process, the control panel
display flashes between the phrases
CHECKING E: MEMORY
and
PRINTER IDLE
.
Note •
Depending on the amount of free FLASH memory,
initialization may take up to 1 minute to complete.
Table 9 • Printer Parameters (Sheet 12 of 26)
Parameter
Action/Explanation
INIT FLASH MEM.
YES