Rockwell Automation 45BPD Analog Laser Sensor - Manual (Page 7)

7
LED Indicators (Teach-in Mode)
Figure 5
➊ The status indicator LED can be steady or blinking depending on the Teach-In setting.
Setting the Sensor
The 45BPD is set up using the pushbuttons (SET and X ) and the LED indicators on the top of the sensor.
To begin the Teach-In process, press the SET and
X
and buttons simultaneously for 3 seconds. The Power/Teach-
In LED will begin to blink when the sensor is in the Teach-In mode.
Scrolling through the Teach-In functions is done using the X button and is indicated as shown in Figure 5. There
are five possible settings (Q, Q
A
, Av, Nc, R). To skip over a function and not change a setting, press the
X
button
to advance to the next desired function. After the last function is reached the menu is started again from the first
function.
To teach the selected function indicated by the teach-in LEDs, press the SET button.
Step 1—Setting the Discrete Output Q
The discrete output can be set with either a switchpoint or switching window as described.
Switchpoint
Press the X button until the “Q” LED turns on indicating that this function can be set.
Position the target at the desired switchpoint.
Press the SET button and the status indicator LED will begin to blink. This sets the switchpoint.
Press the X button to advance to the next setting or press the SET and X and buttons simultaneously for 1
second to exit the Teach-In process.
Switching Window
Press the
X
button until the “Q” LED turns on indicating that this function can be set.
Position the target at the first limit for the switching window.
Press the SET button and the status indicator LED will begin to blink. This sets the first limit.
Position the target at the second limit for the switching window.
Press the SET button and the status indicator LED will turn on as long as SET is pressed to confirm. This sets the
second limit.
Press the
X
button to advance to the next setting or press the SET and
X
and buttons simultaneously for 1
second to exit the Teach-In process.
N
C
6
7
9
&
4 $
2 .
) 6
W L
[
(
I
Q
R
&
4
$
1
7
5
5
SET
Q QA
OK
R
A
V
5
Sensor can be reset
to factory settings
(Green)
Sensor detects target within
operating range with sufficient
margin (Green)
QA output can be set
(Yellow)
Q output configuration
can be set (N.O./N.C.)
(Green)
Averaging mode
function can be set
(Green)
Q output can be set
(Yellow)
Power/Teach-in
(Blinking Green)
Status indicator
(Red
–)
SET button for
Teach-in mode
Scroll button advances to the
next function in Teach-in mode