Yamato Scientific BH500 Thermo-Elite - Manual (Page 41)

38
Flowchart of Operational Procedures
Flowchart for programming
Segment configuration
: Segments are made up of the
following items, and must be input
in this order.
Ramp time
Time
Temperature
Ramp level
Soak time
Ramp time
Rising time
Ramp level
Target
temperature
Soak time
Time held at ramp
level
Wait function
Selects whether to
give priority to
soak time (OFF),
or to hold process
time at ramp level
(ON).
Call up the program mode.
Call up the program number that you want to input
or edit.
When you want to rewrite programs, call up your
desired segment number on the main display.
Note that this will appear in case of editing.
Input Ramp time.
Note: When you run this unit with full power, input
.
Input Ramp level.
Input Soak time.
Note: If there is no soak time (changing
immediately to next temperature), input 0.
To hold, select
Select wait function.
Set the strength of stream while circulating by
pushing either the
▲ key or the ▼ key. The
strength of stream can be changed in the range
from 1 to 10.
The next segment will appear.
Note: To repeat, press either the ▲ key or the ▼ key to
display , and select it with the ENTER key.
Input the segment number that you want to repeat,
and then do the repeat count.
* Input all the settings in the same way.
When finished inputting all items, select for
the ramp time, and press the ENTER key.
▲ ▼
MODE
key
▲ ▼
▲ ▼
▲ ▼
▲ ▼
▲ ▼
▲ ▼
▲ ▼
ENTER
key
▲ ▼
Press
▲ ▼ Key
Settings
finished
Key
Key
Key
Key
Key
Key
Key
Key
Key
ENTER
key
ENTER
key
ENTER
key
ENTER
key
ENTER
key
ENTER
key
ENTER
key
ENTER
key
▲ ▼ Key
ENTER
key
▲ ▼ Key
ENTER
key
Set the strength of stream while circulating by
pushing either the
▲ key or the ▼ key. The
strength of stream can be changed in the range
from 1 to 10.