Western Digital My Cloud Mirror User Manual - Manual (Page 16)

GETTING STARTED
11 WD MY CLOUD MIRROR PERSONAL CLOUD STORAGE
USER MANUAL
1. Using the provided Ethernet cable, connect one end of the Ethernet cable to the
Ethernet port located on the back of the device.
2. Connect the other end of the Ethernet cable directly into a router or network switch port.
3. Connect one end of the power adapter into the power supply socket on the back of the
device.
4. Plug the other end of the power adapter into a power outlet. The unit powers up
automatically.
5. When the power LED on your device turns a solid blue, continue to “Getting Started
Using Online Setup Software” on page 11.
Getting Started Using Online Setup Software
The online setup software walks you through the steps to easily connect your device to your
home or small office network. Use the following steps to download and run the online setup
software, discover the device, and get started using it. The online setup software is available
from WD’s Online Learning Center at
http://wd.com/setup/wdmycloudmirror
Downloading and Installing the Online Setup Software
After connecting your device:
1. Open a web browser. (For browser requirements, see “Web Browsers” on page 6.)
2. In the address field, type http://wd.com/setup/wdmycloudmirror to display the Welcome
to the Learning Center page:
Important: Wait for the WD My Cloud Mirror device to finish powering up
(approximately three minutes) before configuring it. You will know
it is ready when the power LED stops flashing and turns blue.