Inserting a drive, Preparing a drive, Inserting one or both drives – Western Digital My Cloud Mirror User Manual User Manual

Page 139: Inserting a drive preparing a drive

Replacing a Drive

134

WD MY CLOUD MIRROR PERSONAL CLOUD STORAGE

USER MANUAL

Inserting a Drive

Preparing a Drive

For WD replacement drives, reuse the screws and tabs attached to the faulty drive.

Note:

A standard phillips-head screwdriver is all you need.

1. Using the parts from the faulty drive, attach a plastic tab to the top hole in the drive’s side

(on the right if the green board is facing you).

2. Attach a screw to the corresponding hole on the other side of the drive.

3. Attach label 1 or 2 to the top of the drive. Label 1 is on the left and label 2 is on the right,

when looking down on the top of the unit. There are corresponding numbers on the
cross brace label.

Inserting One or Both Drives

Important:

To avoid electrostatic discharge (ESD) problems, ground yourself by

touching metal before handling the device.