Waldmann PULSE HFMD version VFC IV - without MFT - Manual (Page 9)

9
Operating Manual Light Control „PULSE HFMD - Vers. IV without MFT“ ENG
Change basic settings - Part 2
Change setting
The LED I indicates whether a
function is active (ON) or inactive
(OFF) by permanent lighting or
flashing, e.g.:
- LED I permanently lit:
function is active (ON)
- LED I flashing:
function is inactive (OFF)
The function can be activated or
deactivated by using the key I.
Leave parameterisation mode
The parameterisation mode is left
if no switch has been pressed
for 10 seconds. The settings are
stored.
Fig. 4
Key I
+ LED I
Sensor Key II
+ LED II