Waldmann PULSE HFMD version VFC IV - without MFT - Manual (Page 22)

22
Operating Manual Light Control „PULSE HFMD - Vers. IV without MFT“ ENG
Function 2.4
Sensor LED
Function to switch both LEDs in the
sensor operating panel on and off.
The default setting of the function
is “ON“, i.e., the LEDs in the light
head are switched on.
If the function is switched on, the
LEDs in the light head light up
additionally to the light bar display
if a column operating panel (multi-
functional key) is available.
The function can be changed on
lights with sensors XXX /P
if equipped with column operation
panel (multifunctional switch).
Function 2.5
Continuous operation
Setting function for continuous
operation.
The default setting of the function
is “OFF“.
The light operates continuously if
the function is switched on. Even
if no presence is detected, the light
lights at the lowest level.
The function can be changed on
lights with sensors XXX /P
Explanation of the functions (part 5)
Fig. 4
Key I
+ LED I
Sensor Key II
+ LED II
Note: The functions written
in blue are not available.
Function 2.6
Parameter setting protection
Function for activating the param-
eter setting protection (required for
final inspection)
By default, the function is set to
"OFF".
When the function is switched on,
a factory reset will not overwrite
the set parameters. The parameter
setting of the electronic ballast
units will be carried out.
The function can be changed on
lights with sensors XXX /P