Waldmann PULSE HFMD version VFC IV - without MFT - Manual (Page 21)

21
Operating Manual Light Control „PULSE HFMD - Vers. IV without MFT“ ENG
Function 2.3
Dual sensors
Function for the adjustment of the
operating mode when used with
an additional presence sensor
(optional accessories).
The default setting of this function
is “OFF”, i.e., the switch-on au-
tomatic works when a presence
is detected by one of the two
sensors.
Both sensors must detect a pre-
sence to turn on the light if this
function is active.
The function can be changed on
lights with sensors XXX /P
Explanation of the functions (part 4)
Function 2.2
Switch-on automatic
Function to admit or to suppress
automatic switch-on with insuffi-
cient light or in case of presence
(semi-automatic).
The default setting of this function
is ”ON”, i.e., the light is automatical-
ly switched on in case of presence
or insufficient light.
The light has to be switched on ma-
nually even in case presence was
detected if the switch-on automatic
is inactive.
The function can be changed on
lights with sensors XXX /P
Fig. 4
Key I
+ LED I
Sensor Key II
+ LED II
Function 2.1
Sensitivity high
Function to change the sensitivity
of the presence control.
The function is basically set to
„ON”, i.e., the presence sensor has
a normal sensitivity (100%). Small
movements are also detected
within the detection range of the
sensor.
The presence sensor works with
reduced sensibility (approx. 50%) if
the function is set to “OFF”. Small
movements within the detection
range of the sensor are not de-
tected anymore.
The function can be changed on
lights with sensors XXX /P
Note: The functions written
in blue are not available.