Waldmann PULSE HFMD version VFC IV - without MFT - Manual (Page 19)

19
Operating Manual Light Control „PULSE HFMD - Vers. IV without MFT“ ENG
Function 1.5
Light control
Function for the automatic readjus-
tment of the set brightness in case
the ambient brightness changes.
The default setting of this function
is “ON”, i.e., the light control is
active.
The light is dimmable with the light
control switched off.
The function can be changed on
lights with sensors XXX /P
Function 1.6
Presence control
Function to detect the presence
of persons.
The default setting of this function
is “ON”, i.e., the presence control
is active.
If the function is switched on, the
light automatically switches off,
if for a certain time no presence
is detected.
If the presence control is switched
off, the light functions as a light
with light control or as dimmable
light.
The function can be changed on
lights with sensors XXX /P
Explanation of the functions (part 2)
Function 1.4
Write protection
Function for admission or avo-
idance of setting variations.
The default setting of the function
is “OFF“, i.e., the set levels can be
overwritten at any time.
The levels cannot be changed if the
write protection is active.
The function can be changed on
lights with sensors XXX /P
Fig. 4
Key I
+ LED I
Sensor Key II
+ LED II
Note: The functions written
in blue are not available.