Vicor VI Chip Remote Sense PRM Evaluation Board - Manual (Page 4)

UG:016 vicorpower.com Applications Engineering: 800 927.9474 Page 4
Features
1. Input and output lugs for source and load connections.
2. Input fuse (appropriately rated).
3. Input filtering and sockets to place through-hole input aluminum-electrolytic
capacitor for source decoupling.
4. Output filtering and sockets to place through-hole output
aluminum-electrolytic capacitor.
5. Switch for enabling and disabling the PRM through the ENABLE pin.
6. Open drain MOSFET for enabling and disabling the PRM using external source.
7. Mode selection switch for Remote Sense PRM configurations.
8. Trim control selection. (Not applied)
9. Adaptive Loop control selection. (Not applied)
10. Output current sensing for output current measurement and current feedback in
Remote Sense Operation.
11. Sockets and circuits to optimize the external control circuits in
Remote Sense Operation.
12. Voltage reference to trim pot for adjusting output voltage set point in
Remote Sense Operation.
13. Dual output connectors for transferring the power and signal connections to
downstream VTM ® evaluation board.
14. Oscilloscope probe jack for making accurate output voltage measurements.
15. Dual paralleling connectors for PC, PR and SG signal connections to
other PRM evaluation board.
16. Kelvin voltage test points and sockets for all pins of PRM.
17. Test points for current sensing and AC signal injection (RS mode).
18. Provision for installing the heat sink.