UVP ChemiDoc-It 2 Imagers - Manual (Page 15)

GelDoc-It
2
and ChemiDoc-It
2
Imagers 15
Using the System
Powering Up the System
Once plugged in to a surge-protected wall outlet, the GelDoc-It 2 and ChemiDoc-It 2 systems are always
powered on. Power to specific system components, including epi and transillumination lighting, is controlled
by switches located on the front of the unit.
If using the GelDoc-It
2
system with the GelCam 310 camera, turn on the power switch for the Lens Control
Box (see “Camera Setup” for more information).
The White Light and Ultraviolet power switches are three-way rocker switches. Selecting the upper switch
position will turn on the corresponding epi illumination. Selecting the lower switch position will turn on the
corresponding transillumination. Finally, selecting the middle switch position will turn off the lighting.
UV Timer
For UV light protection and to extend the life of the UV transilluminator, there is a ten-minute
transilluminator UV Timer installed in the system. The timer shuts off the transilluminator after ten
minutes of operation. Press the button on the front of the darkroom to reset the timer.
NOTE: When the darkroom door is opened and closed again, the UV timer is automatically reset.
Using the Filters
When installing emission filters in the GelDoc-It
2
and ChemiDoc-It
2
, the user should note the location of the
emission filter selector knob located on the front of the system (pictured below). After installing all filters,
write the name of the filter in the white area next to the filter numbers (1-4).
To change to a different filter, turn the filter selector knob to the desired location. Ensure that the knob clicks
into place to verify that the filter is positioned correctly.
Write the name of the
filter in the white space
next to the filter number