UVP ChemiDoc-It 2 Imagers - Manual (Page 11)

GelDoc-It
2
and ChemiDoc-It
2
Imagers 11
7. Plug the serial cable from the motorized lens
into the lens control box.
8. Connect the USB cable to the PC connection
port on the lens control box. Leave the other
end of the USB cable unplugged until
installation of VisionWorksLS is complete.
9. Connect the power supply to the lens control
box and into the power outlet.
MegaCam 810, OptiChemi 610 and BioChemi 510 Cameras
Specifications MegaCam 810 OptiChemi 610 BioChemi 510
Type CCD, Monochrome CCD, Monochrome CCD, Monochrome
Resolution 3296 x 2472 2184 x 1472 2.1MP
Bit Depth 16-bit 16-bit 16-bit
Quantum Efficiency 50% peak 86% peak 50% peak
Cooling -
35˚C from Ambient
-
50˚C from Ambient
-35
˚C from Ambient
Binning Yes, 1x1 thru 8x8 Yes, 1x1 thru 10x10 Yes, 1x1 thru 8x8
PC Interface USB USB USB
Components
Note: Some components may not be shipped with all systems.
Note: The MegaCam 810, OptiChemi 610 and BioChemi 510 cameras use many of the same
components and are installed in a similar manner. Therefore, the installation instructions herein will
refer to all three cameras interchangeably.
PC Connection on the
Lens Control Box
Power supply on the
Lens Control Box