USG Geometrix Panels Wall Mount Solution - Manual (Page 8)

Trademarks
The following are trademarks
of USG Interiors, Inc. or a
related company: A COUSTIBOND ,
C ELEBRATION , D ONN , G EOMETRIX .
Note
All products described here
may not be available in all
geographic markets and are
subject to change without
notice. Consult your local
sales office or representative
for information.
IC508/12-06
© 2006, USG Corporation
Printed in U.S.A. Manufactured by
USG Interiors, Inc.
550 West Adams Street
Chicago, IL 60661
Notice
We shall not be liable for
incidental or consequential
damages, directly or indirectly
sustained, nor for any loss
caused by application of these
goods not in accordance with
current printed instruction or
for other than intended use.
Our liability is expressly limited
to replacement of defective
goods. Any claim shall be
deemed waived unless made in
writing to us within thirty (30)
days from the date it was or
reasonably should have been
discovered.
Safety First!
Follow good safety and
industrial hygiene practices
during handling and installation
of all products and systems.
Take necessary precautions
and wear appropriate personal
protective equipment as
needed. Read material safety
data sheets and related
literature on products before
specification and/or installation.
800 USG-4YOU (874.4968)
www.usg.com
Limitations
Wall Flatness As detailed, the wall should be flat, within about 1/2; any out-of-flat condition will be noticeable along
the bottom edge of perimeter trim. With shimming and framing, the wall could be almost any condition,
so long as the perimeter appearance can be made subjectively acceptable.
Wall Applications The systems described here are for wall applications only. C
ELEBRATION
and G
EOMETRIX
panels should
not be installed as a ceiling using wall-mount hardware. Ceiling applications require an approved D
ONN ®
brand suspension system.
Interior Use Only Wall-mounted system desinged for interior applications only.
Impact Protection Because C ELEBRATION and G EOMETRIX panels were designed for ceiling applications and not to withstand impacts
from foot traffic, rolling carts and other incidental contact, USG strongly recommends that panels be installed
above or away from floor activity.